Screws for stock iron

lugerholsterrepair · 03-19-2013, 09:59 AM

are broken off..That's not something I have ever seen. Were they broken off in the holes and you had to back them out or what?

I agree with George..Get em where you can find em. Their rare. If Patrice has a set you are a lucky man.

PatrickB · 03-19-2013, 11:15 AM

Quote:

Originally Posted by lugerholsterrepair

are broken off..That's not something I have ever seen. Were they broken off in the holes and you had to back them out or what?

I agree with George..Get em where you can find em. Their rare. If Patrice has a set you are a lucky man.

Only the bottom 1/4" or less has threads. Both bolts had the threaded portion broken off when I got the stock, and the broken pieces had already been removed. The iron was being held on only with the friction on the bolts in the wood. I didn't realize anything was wrong until I tried to tighten the iron by turning the screw heads.

I will try to contact LU1900.

03-19-2013, 09:59 AM	#1
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	are broken off..That's not something I have ever seen. Were they broken off in the holes and you had to back them out or what? I agree with George..Get em where you can find em. Their rare. If Patrice has a set you are a lucky man. __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode