![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
|
|
|
#1 | |
|
User
Join Date: Mar 2012
Location: Bucyrus OH
Posts: 60
Thanks: 1
Thanked 7 Times in 7 Posts
|
Quote:
|
|
|
|
|
|
|
#2 |
|
User
Join Date: Aug 2008
Posts: 24
Thanks: 16
Thanked 0 Times in 0 Posts
|
Yes I pushed the bar the way you described and the firing pin released. I noticed the spring on the back of the trigger is compressed so I took the trigger and side plate from a pistol that works fine and installed it on the faulty pistol and the same problem happens. Doesn't that eliminate the side plate and trigger?
|
|
|
|
|
|
#3 |
|
User
Join Date: Aug 2008
Posts: 24
Thanks: 16
Thanked 0 Times in 0 Posts
|
Thanks to all of you folks I figured there should be no gap between the side plate and slide. If I pretend I have 3 hands I might be able to eliminate the gap thusly: 1. Press and hold the side plate against the slide as hard as possible to eliminate the gap. 2. Press the muzzle toward the back of the pistol. 3. Slide the locking bolt up 90 degrees to lock the side plate in place.
4. Dry fire the pistol over a dozen times without a miss. Problem solved. |
|
|
|
|
|
#4 |
|
Patron
LugerForum Patron Join Date: Mar 2011
Location: Az.
Posts: 2,316
Thanks: 2,768
Thanked 1,000 Times in 735 Posts
|
Glad to hear that you found/solved your problem. What you described as to how to place the side plate, put rearward pressure on the muzzle, then rotate the locking bolt by 90 degrees, is the standard method of reassembling a P08. I am not sure what you did differently before. Anyway, enjoy!!
|
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|