mag id?

mrerick · 02-20-2012, 09:34 AM

Hi,

Is there a small dent in the aluminum base magazine, near the front edge in the first photo? That could be causing interference in the frame channel. Gerald Tomak "G.T." has the fixtures and the skill to fix that if you need to.

Look carefully all over the aluminum base magazine for a very small "42" or "S/42". It's hard to tell due to lack of focus in your last picture, but it doesn't look like a serial has been scrubbed from it's base. It could be an armorer's replacement magazine.

Marc

02-20-2012, 09:34 AM	#1
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,925 Thanks: 1,377 Thanked 3,140 Times in 1,520 Posts	Hi, Is there a small dent in the aluminum base magazine, near the front edge in the first photo? That could be causing interference in the frame channel. Gerald Tomak "G.T." has the fixtures and the skill to fix that if you need to. Look carefully all over the aluminum base magazine for a very small "42" or "S/42". It's hard to tell due to lack of focus in your last picture, but it doesn't look like a serial has been scrubbed from it's base. It could be an armorer's replacement magazine. Marc __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode