East German Luger

Vlim · 07-16-2011, 05:26 PM

Michael, we indeed discuss the quality issues that the Dutch magazines had initially. We also discuss the use of castings for many of the small parts and the rear parts of the toggle assembly, as well as the use of sintering to produce the firing pin.

I don't know were you got the 'loosely fitting' and 'porous casting' ideas from. I expect it is lack of knowledge of the subject. Again, I recommend reading the book.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-16-2011, 05:26 PM	#14
Vlim Moderator Lifetime LugerForum Patron Join Date: Oct 2002 Location: Europe Posts: 5,053 Thanks: 1,036 Thanked 3,991 Times in 1,205 Posts	Michael, we indeed discuss the quality issues that the Dutch magazines had initially. We also discuss the use of castings for many of the small parts and the rear parts of the toggle assembly, as well as the use of sintering to produce the firing pin. I don't know were you got the 'loosely fitting' and 'porous casting' ideas from. I expect it is lack of knowledge of the subject. Again, I recommend reading the book.