Please Help Identify Unit Marking on 1916 DWM

bdome · 04-20-2011, 10:57 PM

You are correct Don. When I removed the side cover I could clearly see the hole which was drilled in the sear bar. Thank you for the clarification. I've read that it was a requirement for the sear safety to be installed on pistols used by the police. Was it commonplace to remove these sear safeties once they were removed from police service? I'm just curious why it may have been modified but then removed. Thanks again.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-20-2011, 10:57 PM	#9
bdome User Join Date: Apr 2011 Location: Twin Cities, MN Posts: 14 Thanks: 1 Thanked 1 Time in 1 Post	You are correct Don. When I removed the side cover I could clearly see the hole which was drilled in the sear bar. Thank you for the clarification. I've read that it was a requirement for the sear safety to be installed on pistols used by the police. Was it commonplace to remove these sear safeties once they were removed from police service? I'm just curious why it may have been modified but then removed. Thanks again.