![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
|
|
|
#1 |
|
Patron
LugerForum Patron Join Date: Jun 2002
Location: POB 398 St.Charles,MO. 63302
Posts: 5,089
Thanks: 6
Thanked 737 Times in 484 Posts
|
Chris, In leiu of a correct sized pin punch, you could try removing the old spring with the rear of HO in a soft jawed vice and using a small bladed screw driver to push it off the HO from right to left. TH
|
|
|
|
| The following member says Thank You to Lugerdoc for your post: |
|
|
#2 |
|
User
Join Date: Nov 2010
Location: Georgia
Posts: 41
Thanks: 1
Thanked 20 Times in 8 Posts
|
Vlim and All:
Just installed the new hold open spring I got from Tom Heller. Easy job if you look at the video. (about a five minute job) I could see right away the old spring had flattened out after almost 100 years, and the new one had a nice curve to it. Put 100 rounds through it, with 2 different mags, and all 8 rounds fired, then went to hold open like it should. Couldn't have worked better. Next, after seeing the worn out spring, I'm going to order a Wolf spring kit and change all the others just for good measure. Thanks so much for all the good information, you were spot on. Tom checkfeo |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|