Toggle Won't Lock in the Back Position

FNorm · 11-14-2010, 06:49 PM

When you have an empty mag in, the follower button on the mag should push a little lever up and hold the toggle back. First thing is to see if you have this hold back device installed

Here it is the piece #48, running along the inner rt. side of the frame, then the cross piece just behind the magazine well.

FN

jimw · 11-16-2010, 06:55 AM

Thanks FNorm. Finally got around to taking the gun apart yesterday. What I found is that the magazine has a little slack in it. It does not lock tight up into the slot. If I press on the bottom of the empty magazine while pulling back the toggle, it locks back like it is supposed to.

I guess I need to look into why the magazine isn't locking tight into the slot. Is there somewhere I can get another Luger 30 magazine?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-16-2010, 06:55 AM	#2
jimw User Join Date: Nov 2010 Posts: 5 Thanks: 0 Thanked 0 Times in 0 Posts	Thanks FNorm. Finally got around to taking the gun apart yesterday. What I found is that the magazine has a little slack in it. It does not lock tight up into the slot. If I press on the bottom of the empty magazine while pulling back the toggle, it locks back like it is supposed to. I guess I need to look into why the magazine isn't locking tight into the slot. Is there somewhere I can get another Luger 30 magazine?