RWS 9mm Ammo and Lugers

PhantomF4E · 05-17-2010, 09:16 PM

If you are a reloader like me DAG, RWS, GeCo brands may pose an issue. DAG brass has a smaller flash hole than most brass and standard decapping pins and will not cycle through. Pretty good quality brass though so I drilled out a few hunderd of them a 5/64" bit will get the flash hole to the right size. Reload away ! 124gn Montana gold fmj,CCI500 primer and 4.1gns Vitahvouri n320 C.o.l 1.142" It is a beautiful thing. Powder is a bit pricey but it is so clean you can burn hundreds of rounds with almost no fouling.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-17-2010, 09:16 PM	#14
PhantomF4E New User Join Date: Dec 2009 Posts: 4 Thanks: 1 Thanked 0 Times in 0 Posts	If you are a reloader like me DAG, RWS, GeCo brands may pose an issue. DAG brass has a smaller flash hole than most brass and standard decapping pins and will not cycle through. Pretty good quality brass though so I drilled out a few hunderd of them a 5/64" bit will get the flash hole to the right size. Reload away ! 124gn Montana gold fmj,CCI500 primer and 4.1gns Vitahvouri n320 C.o.l 1.142" It is a beautiful thing. Powder is a bit pricey but it is so clean you can burn hundreds of rounds with almost no fouling.