LP-08 Witness Mark Missing

mrerick · 05-17-2010, 07:59 PM

I took a very close look at the mark, and it looks like an original witness mark on the receiver was re-struck leaving the final mark on the receiver.

The receiver is about 1mm higher than the barrel, and the witness mark strike compressed the metal down against the barrel, but not into the barrel metal.

As mentioned above, most likely a "too light" strike...

Thanks again for looking and the help!

Marc

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-17-2010, 07:59 PM	#1
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,925 Thanks: 1,377 Thanked 3,140 Times in 1,520 Posts	I took a very close look at the mark, and it looks like an original witness mark on the receiver was re-struck leaving the final mark on the receiver. The receiver is about 1mm higher than the barrel, and the witness mark strike compressed the metal down against the barrel, but not into the barrel metal. As mentioned above, most likely a "too light" strike... Thanks again for looking and the help! Marc