Problem with P08

mrerick · 01-31-2010, 11:32 AM

Hi,

Part 19 is a leaf spring, curled around toward the front of the pistol, and flat toward the back. It normally slides into a slot and presses down on the sear.

Is the front part of this leaf spring missing?

It's possible that it's jammed behind the sear (part 19). Can you move or remove the sear?

The sear is held in place by a short leaf spring that closes a half circle and holds it against a pin in the frame.

Marc

01-31-2010, 11:32 AM	#1
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,925 Thanks: 1,377 Thanked 3,140 Times in 1,520 Posts	Part 19 Hi, Part 19 is a leaf spring, curled around toward the front of the pistol, and flat toward the back. It normally slides into a slot and presses down on the sear. Is the front part of this leaf spring missing? It's possible that it's jammed behind the sear (part 19). Can you move or remove the sear? The sear is held in place by a short leaf spring that closes a half circle and holds it against a pin in the frame. Marc

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode