1917 barrel fork broken in 3 pieces

jamese · 06-14-2009, 09:06 AM

Alx,
I see thats a Glock 21, is that one on the photos from an Agency in Washington State ?

I think they had a couple of Glocks that let loose and it turned out to be an ammo problem as

recall.

If this is not the case can you advise me the info on this ?

Thank you

Jim

Mauser George · 06-14-2009, 11:55 AM

All this sure makes me glad I took up reloading years ago. I don't think I have purchased factory ammo in 15 years except for Winchester Silvertip for my carry pistol.

Sure looks like a nasty thing to have happen not to mention destroying your pistol!

Regards,

George

LugerVern · 06-14-2009, 12:22 PM

The gun broke at a stress point for a Luger ( lug contacting frame) but I would like to see pictures of the rear of the breach block and both the inside and outside rear of the frame?

Damage usually occurs in these areas from too hot of ammo long before the receiver lets go.

"Great show and tell pictures!!!"

Vern

Alx · 06-14-2009, 11:48 PM

'got called away to New Hampshire for a week, but next week after , 'will take photos of breechblock face, receiver lug, and frame areas. As far as the gunsmith that installed the barrel, He evidently did not have the correct equipment to turn out the barrel with leverage alone, and used a torch to expand the fit.

06-14-2009, 09:06 AM	#1
jamese User Join Date: Jan 2003 Location: South Florida Posts: 792 Thanks: 0 Thanked 86 Times in 36 Posts	Alx, I see thats a Glock 21, is that one on the photos from an Agency in Washington State ? I think they had a couple of Glocks that let loose and it turned out to be an ammo problem as recall. If this is not the case can you advise me the info on this ? Thank you Jim __________________ The "truth" is a matter of Perception

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

06-14-2009, 11:55 AM	#2
Mauser George User Join Date: Sep 2008 Location: New York Posts: 88 Thanks: 0 Thanked 2 Times in 2 Posts	All this sure makes me glad I took up reloading years ago. I don't think I have purchased factory ammo in 15 years except for Winchester Silvertip for my carry pistol. Sure looks like a nasty thing to have happen not to mention destroying your pistol! Regards, George

06-14-2009, 12:22 PM	#3
LugerVern User Join Date: Apr 2005 Location: Virginia Posts: 563 Thanks: 1 Thanked 34 Times in 27 Posts	The gun broke at a stress point for a Luger ( lug contacting frame) but I would like to see pictures of the rear of the breach block and both the inside and outside rear of the frame? Damage usually occurs in these areas from too hot of ammo long before the receiver lets go. "Great show and tell pictures!!!" Vern

06-14-2009, 11:48 PM	#4
Alx User Join Date: Sep 2006 Location: Nashville, Tennessee area Posts: 263 Thanks: 5 Thanked 3 Times in 3 Posts	'got called away to New Hampshire for a week, but next week after , 'will take photos of breechblock face, receiver lug, and frame areas. As far as the gunsmith that installed the barrel, He evidently did not have the correct equipment to turn out the barrel with leverage alone, and used a torch to expand the fit.