Code 42 Plastic grips

John Sabato · 02-17-2009, 11:13 AM

Your grips are a low quality reproduction set that have been molded by the very process you have described. they are not original to the gun. Please post a few more photos of all areas where serial numbers and part numbers appear. Please make sure they are in sharp focus and as reflectionless as possible. I believe that at least some parts of your gun have been renumbered...

lypet · 02-17-2009, 08:09 PM

Certainly the firing pin is renumbered. There is a flat spot where the old one was removed. The right side of the chamber has the faint image of two of the eagle over 135 stamps. This leads me to the conclusion that I have a good looking shooter.

Thanks,
Lynn

02-17-2009, 11:13 AM	#1
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,309 Times in 1,098 Posts	Your grips are a low quality reproduction set that have been molded by the very process you have described. they are not original to the gun. Please post a few more photos of all areas where serial numbers and part numbers appear. Please make sure they are in sharp focus and as reflectionless as possible. I believe that at least some parts of your gun have been renumbered... __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode