![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
|
|
|
#1 |
|
User
Join Date: Feb 2005
Location: Potomac Falls, Virginia USA
Posts: 107
Thanks: 0
Thanked 2 Times in 2 Posts
|
One thing I like about CorrosionX is the guns clean up very easily with it. I fired my DWM Luger this weekend with Winchester White Box and it was a lead pipe cinch to clean afterwards. I only had one malufinction with it in about 100 rounds. It was a failure to fully extract and the next round in the magazine jammed under it. My brass key got it out and the gun functioned perfectly after that. I want to handload some hard cast lead 125 grain bullets to duplicate the performance. Any suggestions?
__________________
All my C&R guns are shooters |
|
|
|
|
|
#2 | |
|
User
Join Date: Jul 2003
Location: New York, NY
Posts: 1,579
Thanks: 2,154
Thanked 402 Times in 251 Posts
|
Quote:
Here is a good target load for you: 3.7 gr of Bullseye OAL (Roundnose) 1.173 inches. Try that one. For me, it is less than an inch at 25 yards (over a sandbag hold). Sieger Last edited by Sieger; 12-09-2008 at 04:52 AM. |
|
|
|
|
|
|
#3 |
|
User
Join Date: Feb 2005
Location: Potomac Falls, Virginia USA
Posts: 107
Thanks: 0
Thanked 2 Times in 2 Posts
|
Excellent, I will try to get some loaded up this week and take it to the range ASAP. Thanks!
__________________
All my C&R guns are shooters |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|