Mitchell Luger

Steve Richards · 02-02-2006, 02:17 AM

Welcome to the forum!

I have two of the stainless guns. For cleaning, I use Hoppe's on a Boresnake for the bore and Tetra cleaning spray and a toothbrush for everything else. Just be careful when removing the left grip! Take the right grip of first and after removing the left screw, push the bottom of the left grip out just enough to clear the bottom of the frame and slide the grip down. If you try to just lift it out you will break the top rear projection of the grip.

Other than that, the stainless guns do not seam to take any special care.

Steve

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-02-2006, 02:17 AM	#9
Steve Richards User Join Date: Jun 2002 Location: Beaverton, Oregon Posts: 487 Thanks: 0 Thanked 1 Time in 1 Post	Welcome to the forum! I have two of the stainless guns. For cleaning, I use Hoppe's on a Boresnake for the bore and Tetra cleaning spray and a toothbrush for everything else. Just be careful when removing the left grip! Take the right grip of first and after removing the left screw, push the bottom of the left grip out just enough to clear the bottom of the frame and slide the grip down. If you try to just lift it out you will break the top rear projection of the grip. Other than that, the stainless guns do not seam to take any special care. Steve