Original DWM Truncated Cone Bullet

Doubs · 07-23-2003, 10:32 PM

Bob, the Lee TC mold I have is the single grease groove and not the tumble lube design. I hesitate to use tumble lube on a bullet I load for the Luger as the nose of the Luger cartridge rides on the forward groove of the magazine as it moves upward and I'm concerned that the lube might not allow the bullet to slide as easily as the unlubed bullet. It may work fine but I haven't tried them for that reason.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-23-2003, 10:32 PM	#14
Doubs User Join Date: Jun 2002 Location: Byron, Georgia Posts: 1,753 Thanks: 845 Thanked 1,826 Times in 601 Posts	Bob, the Lee TC mold I have is the single grease groove and not the tumble lube design. I hesitate to use tumble lube on a bullet I load for the Luger as the nose of the Luger cartridge rides on the forward groove of the magazine as it moves upward and I'm concerned that the lube might not allow the bullet to slide as easily as the unlubed bullet. It may work fine but I haven't tried them for that reason.