fails to"fire"

Thor · 05-31-2004, 08:21 PM

Make sure it is empty first and foremost then follow until step three. If you get the top (receiver/barrel/toggle) off you can check sear bar rotation with all three intact. Push the front (left end with muzzle to left) end of the sear bar inwards, this should release the firing pin and bend the sear spring, when you release the sear bar should go back to its relaxed or prefiring position. Only if the firing pin is caught by the sear bar will the firing pin go forward when you press the bar inwards.
Luger Disassembly CLICK HERE

05-31-2004, 08:21 PM	#9
Thor User Join Date: Jun 2002 Location: Rio Rancho, New Mexico Posts: 4,583 Thanks: 958 Thanked 971 Times in 277 Posts	Make sure it is empty first and foremost then follow until step three. If you get the top (receiver/barrel/toggle) off you can check sear bar rotation with all three intact. Push the front (left end with muzzle to left) end of the sear bar inwards, this should release the firing pin and bend the sear spring, when you release the sear bar should go back to its relaxed or prefiring position. Only if the firing pin is caught by the sear bar will the firing pin go forward when you press the bar inwards. Luger Disassembly CLICK HERE __________________ Thor's Luger Clinic http://members.rennlist.com/lugerman/ Ted Green (Thor Yaller Boots) 725 Western Hills Dr SE, Rio Rancho, NM 87124 915-526-8925 Email thor340@aol.com ----------------------------------- John3:3 Jesus answered and said to him, "Most assuredly, I say to you, unless one is born again, he cannot see the kingdom of God."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode