Superb 08 Sight Wrench...

G.T. · 09-06-2004, 11:02 PM

Hi John D!! Not a silly question at all! But, if the tool is made to the correct dimensions..the set screw kinda becomes redundant.... at least I have yet to see them on other tools! The best tools for the 1900 type .30 cal. have a notch machined in them, so that the sq. front sight block fits into, so that it can't go back and forth... lot'sa good ideas..making them affordable is the tough part... Best to you John D! til...lat'r...GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-06-2004, 11:02 PM	#8
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,546 Thanks: 1,345 Thanked 3,769 Times in 1,025 Posts	Hi John D!! Not a silly question at all! But, if the tool is made to the correct dimensions..the set screw kinda becomes redundant.... at least I have yet to see them on other tools! The best tools for the 1900 type .30 cal. have a notch machined in them, so that the sq. front sight block fits into, so that it can't go back and forth... lot'sa good ideas..making them affordable is the tough part... Best to you John D! til...lat'r...GT