7.65mm. Mauser Banner

bill m · 04-25-2001, 10:10 PM

(1)-The grips should be close to the same color and should fit very well as they were hand fitted. They can be numbered inside with the last two digits or be blank. (These grips could be a couple of things -- reproductions, (which some on this forum say are not being used to deceive), or mis-matched originals.

(2)-The commercial guns were in either 7.65 or 9mm. Either is hard to find in a commercial gun.

(3)-Salt blue with blued or strawed small parts.

04-25-2001, 10:10 PM	#2
bill m User Join Date: Oct 2004 Posts: 385 Thanks: 0 Thanked 0 Times in 0 Posts	Re: 7.65mm. Mauser Banner (1)-The grips should be close to the same color and should fit very well as they were hand fitted. They can be numbered inside with the last two digits or be blank. (These grips could be a couple of things -- reproductions, (which some on this forum say are not being used to deceive), or mis-matched originals. (2)-The commercial guns were in either 7.65 or 9mm. Either is hard to find in a commercial gun. (3)-Salt blue with blued or strawed small parts.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode