Extractor issue? mainspring issue both?

Bryon · 02-04-2003, 05:55 AM

Yes, I was referring to the ejector, my mistake. I also did the test of taking the toggle out and replacing the rear pin, it went in fine. So too much tension the bolt from the Ejector and weak spring = my problem? Can the ejector be torqued back so there is less tension on the bolt, replaced, or grinding the end, or leave it alone?

Is removing the ejector a gunsmith job?

thanks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-04-2003, 05:55 AM	#3
Bryon User Join Date: Jan 2003 Location: CA Posts: 30 Thanks: 0 Thanked 0 Times in 0 Posts	Yes, I was referring to the ejector, my mistake. I also did the test of taking the toggle out and replacing the rear pin, it went in fine. So too much tension the bolt from the Ejector and weak spring = my problem? Can the ejector be torqued back so there is less tension on the bolt, replaced, or grinding the end, or leave it alone? Is removing the ejector a gunsmith job? thanks.