New Member with Old Commercial Luger (I think.)

Karl · 11-04-2022, 10:19 AM

Dear Gerald,

Welcome to the forum. Your photo is a bit dark but from what I can see the Luger appears to be in fine condition. I do not see an advantage in refinishing the gun, and it would significantly reduce the value. Moreover, from the strawed (yellow) parts (trigger, mag release), the gun must have a "cold" rust blued finish rather than the "hot" salt blued finish typically used on modern guns. In short, I advise you to leave it as is.

I encourage you to post more photos.

KFS

11-04-2022, 10:19 AM	#2
Karl Lifer - Twice Over Lifetime Forum Patron Join Date: Jun 2002 Location: Savannah Posts: 533 Thanks: 0 Thanked 285 Times in 125 Posts	Dear Gerald, Welcome to the forum. Your photo is a bit dark but from what I can see the Luger appears to be in fine condition. I do not see an advantage in refinishing the gun, and it would significantly reduce the value. Moreover, from the strawed (yellow) parts (trigger, mag release), the gun must have a "cold" rust blued finish rather than the "hot" salt blued finish typically used on modern guns. In short, I advise you to leave it as is. I encourage you to post more photos. KFS Last edited by Karl; 11-04-2022 at 10:20 AM. Reason: additions

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode