Like fighting the invisible man!!

[G.T.]

Hi to all, well, wasn't too bad, one failure to extract, but ran a few magazings full and had only the one failure? Going to address that going forward. But, repro Navy barrel had a bit too large of width and maybe depth on the extractor relief notch on the barrel, and the brass was slightly bulged? Not so much as it would be an issue, but too much for my liking. Worst part is I'm running out of quality parts? Soooo, I'm currently going to install an original 1906 Navy commercial 9MM barrel (rare as red frogs hairs!) with a .080" spacer to adapt the long tenon barrel to the short tenon receiver?...
By the way, primer strikes looked perfect, ammo was WW target 115 gr. ball, no pressure signs, all looked greast when done... More soon.. best, til...lat'r....GT ...