upload photo | donate | calendar
|
my profile |
register |
faq |
search upload photo | donate | calendar |
07-01-2020, 09:54 AM
|
#14 |
|
Super Moderator - Patron
LugerForum Life Patron 
Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,925
Thanks: 1,377
Thanked 3,140 Times in 1,520 Posts
|
I imagine that the person that "fitted" this revolver barrel to the Luger ran up against the problem of thread angle (remember the preference for British "Whitworth" thread profile by DWM)...
Depending on the source of the "replacement" barrel, it's unlikely that it had the correct thread pitch and face angle, so any number of "adjustments" might have been committed. This site describes the BSW thread: https://www.boltscience.com/pages/screw4.htm This is the Luger:
__________________
 Igitur si vis pacem, para bellum -- Therefore if you want peace, prepare for war. |
|
|
| The following member says Thank You to mrerick for your post: |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode