New Army 9mm Ammo Specs

gunbugs · 05-26-2020, 02:32 PM

I would presume, from the introduction to the database, that they are limiting their analysis to commonly available reloading powders. The database is primarily used to analyze residue from IED's, not from residue from gunshot wounds. Again, the powders used by the factories may, or may not be commonly available. Lot to lot variations in bulk powder preclude use by handloaders seeking consistent results from various lots. Sometimes you will see bulk powders available for sale as "surplus" from pulldown ammunition, and they will tell you to cross-reference with a certain powder, but start loads must be "x" percent lower.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-26-2020, 02:32 PM	#10
gunbugs Lifetime Forum Patron Join Date: Sep 2013 Location: Fairbanks, Alaska. Home of the best moose. Posts: 683 Thanks: 375 Thanked 1,230 Times in 415 Posts	I would presume, from the introduction to the database, that they are limiting their analysis to commonly available reloading powders. The database is primarily used to analyze residue from IED's, not from residue from gunshot wounds. Again, the powders used by the factories may, or may not be commonly available. Lot to lot variations in bulk powder preclude use by handloaders seeking consistent results from various lots. Sometimes you will see bulk powders available for sale as "surplus" from pulldown ammunition, and they will tell you to cross-reference with a certain powder, but start loads must be "x" percent lower.