Trigger job?

mrerick · 03-30-2020, 10:30 PM

*** See Below for PDF copy in High Resolution *** And accept the caveat that the author didn't have the correct reverse angle information Don discusses below.

- - - - - -

In spite of the good information in the article, Luger trigger adjustment is as much an art as anything else, and that art is likely based on some experience.

As Don says, we hear much more often about problems caused than improvement achieved.

Most everything in the complete linkage affects other parts, some of which are covered during operation.

03-30-2020, 10:30 PM	#7
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,925 Thanks: 1,377 Thanked 3,140 Times in 1,520 Posts	* See Below for PDF copy in High Resolution * And accept the caveat that the author didn't have the correct reverse angle information Don discusses below. - - - - - - In spite of the good information in the article, Luger trigger adjustment is as much an art as anything else, and that art is likely based on some experience. As Don says, we hear much more often about problems caused than improvement achieved. Most everything in the complete linkage affects other parts, some of which are covered during operation. __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war. Last edited by mrerick; 04-01-2020 at 10:37 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode