PO8 Problems???

policeluger · 02-15-2003, 04:09 PM

Take the entire top off your Luger and re-install the repo side plate, see if your trigger return spring is strong enough too return the lever. Watch how it works, then install the top, but stripped of the toggle unit and see if your lever is interacting correctly with your sear bar, sometimes a little lube and a little cleaning is all it takes. Sometimes it needs a lot more, then you may need too seek out a gunsmith who knows their away around Lugers

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-15-2003, 04:09 PM	#7
policeluger RIP Join Date: Jun 2002 Location: Ca. Posts: 2,141 Thanks: 8 Thanked 89 Times in 54 Posts	Take the entire top off your Luger and re-install the repo side plate, see if your trigger return spring is strong enough too return the lever. Watch how it works, then install the top, but stripped of the toggle unit and see if your lever is interacting correctly with your sear bar, sometimes a little lube and a little cleaning is all it takes. Sometimes it needs a lot more, then you may need too seek out a gunsmith who knows their away around Lugers