help

G.W. Gill · 12-01-2002, 09:48 PM

Just a shot in the dark. I have had problems with the angle of the top round as it leaves the mag. The top of my mags sometimes get out of line ( a little too narrow or a little too wide ). Most of the time just a little bend in on the obvious two surfaces gets the mag back in sync. One has to be sure of the above mentioned springs. And not be rough in the storage of mags like I have been. <img src="graemlins/a_smil17.gif" border="0" alt="[blabla]" />

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-01-2002, 09:48 PM	#1
G.W. Gill User Join Date: Jun 2002 Location: Southeastern USA Posts: 369 Thanks: 0 Thanked 0 Times in 0 Posts	Just a shot in the dark. I have had problems with the angle of the top round as it leaves the mag. The top of my mags sometimes get out of line ( a little too narrow or a little too wide ). Most of the time just a little bend in on the obvious two surfaces gets the mag back in sync. One has to be sure of the above mentioned springs. And not be rough in the storage of mags like I have been. <img src="graemlins/a_smil17.gif" border="0" alt="[blabla]" />