upload photo | donate | calendar
|
my profile |
register |
faq |
search upload photo | donate | calendar |
04-09-2018, 09:52 AM
|
#14 |
|
Super Moderator - Patron
LugerForum Life Patron 
Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,925
Thanks: 1,377
Thanked 3,140 Times in 1,520 Posts
|
Since all factory shipped Lugers had serial numbers, this is why it's important to verify the metal dimensions in areas that would normally have serial number digits on a "sneak" to be sure that they have not been removed.
In particular, check the width of the front of the receiver slide and verify that the slide is not proud (forward of) the front of the frame - and that the front of the receiver is level where the barrel is screwed in.
__________________
 Igitur si vis pacem, para bellum -- Therefore if you want peace, prepare for war. |
|
|
| The following member says Thank You to mrerick for your post: |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode