P1 finish protection

John Sabato · 08-25-2016, 12:37 PM

This image is actually photoshopped to look like a gun I made for myself back in the 1970's from a mismatched P.38 I built from parts.

In addition to bobbing the hammer and shortening the barrel, I also flattened the contour of the safety and checkered the remaining lever. It was a great carry gun, and reliable as heck.

With a P1 aluminum frame it would be even easier to carry...

I think I would find the P5 to be slightly bulkier than my "shorty."

I always wanted an H&K P7, but could never find one I could afford

08-25-2016, 12:37 PM	#5
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,157 Thanks: 3,003 Thanked 2,311 Times in 1,099 Posts	This image is actually photoshopped to look like a gun I made for myself back in the 1970's from a mismatched P.38 I built from parts. In addition to bobbing the hammer and shortening the barrel, I also flattened the contour of the safety and checkered the remaining lever. It was a great carry gun, and reliable as heck. With a P1 aluminum frame it would be even easier to carry... I think I would find the P5 to be slightly bulkier than my "shorty." I always wanted an H&K P7, but could never find one I could afford __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode