locking bolt spring broken and stuck in frame.

Edward Tinker · 08-11-2016, 08:44 PM

it is a fairly obvious or should be?

perhaps someone filled it in once? But no idea why anyone would do that...

G.T. · 08-11-2016, 08:50 PM

It's just to the left of dead center on your circle? I think? ...You need to fabricate a correct dia. (undersized) pin punch, but it has to be very short... just enough to move the remnant spring tang.. once loose, you can push it out with anything?... GT....

08-11-2016, 08:44 PM	#1
Edward Tinker Super Moderator Eternal Lifer LugerForum Patron Join Date: Jun 2002 Location: North of Spokane, WA Posts: 15,987 Thanks: 2,083 Thanked 4,604 Times in 2,128 Posts	it is a fairly obvious or should be? perhaps someone filled it in once? But no idea why anyone would do that... __________________ Edward Tinker ************ Co-Author of Police Lugers - Co-Author of Simson Lugers Author of Veteran Bring Backs Vol I, Vol II, Vol III and Vol IV

08-11-2016, 08:50 PM	#2
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,550 Thanks: 1,361 Thanked 3,778 Times in 1,028 Posts	I see it! It's just to the left of dead center on your circle? I think? ...You need to fabricate a correct dia. (undersized) pin punch, but it has to be very short... just enough to move the remnant spring tang.. once loose, you can push it out with anything?... GT....

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode