Good reload for a 4" P08

ithacaartist · 06-18-2011, 10:01 PM

A question about modifying a magazine:
One factor in function is friction between the front of the magazine and the noses of the cartridges, right? Has an industrious reloader ever tried lining this inner surface with a Delrin strip? One would seat the bullet into the case a little farther to compensate for the new overall dimension, but this might cover the lube groove--left hangin' out in some combinations to achieve the required overall cartridge length.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-18-2011, 10:01 PM	#15
ithacaartist Twice a Lifer Lifetime Forum Patron Join Date: Mar 2011 Location: Atop the highest hill in Schuyler County NY Posts: 3,410 Thanks: 7,594 Thanked 2,661 Times in 1,399 Posts	A question about modifying a magazine: One factor in function is friction between the front of the magazine and the noses of the cartridges, right? Has an industrious reloader ever tried lining this inner surface with a Delrin strip? One would seat the bullet into the case a little farther to compensate for the new overall dimension, but this might cover the lube groove--left hangin' out in some combinations to achieve the required overall cartridge length.