Who is Stark??

lugerholsterrepair · 04-30-2011, 01:41 PM

German pulls were milled untill East Germany started molding them from what I know.

G.T. · 04-30-2011, 03:52 PM

Hi Doug, one shot of the inside of the base, from the top, will tell us all we need to know.. as the spring seat hole edges will have a small redius relief on the edges if cast, and a machined one will be sharp edged..

.. I think this is a very, very early cast version.. but hard to tell without a look'e'see on the inside...

best to all, til...lat'r...GT

04-30-2011, 01:41 PM	#1
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,994 Thanked 3,134 Times in 1,439 Posts	German pulls were milled untill East Germany started molding them from what I know. __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

04-30-2011, 03:52 PM	#2
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,548 Thanks: 1,345 Thanked 3,771 Times in 1,026 Posts	cast?? Hi Doug, one shot of the inside of the base, from the top, will tell us all we need to know.. as the spring seat hole edges will have a small redius relief on the edges if cast, and a machined one will be sharp edged.... I think this is a very, very early cast version.. but hard to tell without a look'e'see on the inside... best to all, til...lat'r...GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode