Breech Block issues

Lugerdoc · 12-22-2010, 09:54 AM

Your blown BB is not uncommon; this is the area where they usually fail. In the past I've tried several welder to save a matching PO8, but few were able to successfully remove the excess weld from the inside slot in which the retaining piece turns. For shooters, I recommend the use of a Mauser relieved FP, so in the event of a puntured primer, the FP is not driven back like a piston against the rear of the BB. The easiest and probably the least expensive solution is to replace the BB. TH

Thor · 12-22-2010, 10:50 AM

Lugerdoc nailed this one! Good advice!

12-22-2010, 09:54 AM	#1
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 737 Times in 484 Posts	Your blown BB is not uncommon; this is the area where they usually fail. In the past I've tried several welder to save a matching PO8, but few were able to successfully remove the excess weld from the inside slot in which the retaining piece turns. For shooters, I recommend the use of a Mauser relieved FP, so in the event of a puntured primer, the FP is not driven back like a piston against the rear of the BB. The easiest and probably the least expensive solution is to replace the BB. TH __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net

12-22-2010, 10:50 AM	#2
Thor User Join Date: Jun 2002 Location: Rio Rancho, New Mexico Posts: 4,583 Thanks: 958 Thanked 971 Times in 277 Posts	Lugerdoc nailed this one! Good advice! __________________ Thor's Luger Clinic http://members.rennlist.com/lugerman/ Ted Green (Thor Yaller Boots) 725 Western Hills Dr SE, Rio Rancho, NM 87124 915-526-8925 Email thor340@aol.com ----------------------------------- John3:3 Jesus answered and said to him, "Most assuredly, I say to you, unless one is born again, he cannot see the kingdom of God."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode