C 96 Help

Fazer · 10-18-2009, 09:55 PM

Basicaly they wanted the hammer not to stike the firing pin if it slipped from your thumb while cocking it. I added a small block to the arch on the hammer, up the back. This gave me a half cook and a stopper for the hammer if it slipped. Luckely the sear raises enough to miss the block when the trigger is pulled, but is low enough to catch it when it's not. All in all, not a bad addition to be honest. But most of all it kept them happy.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-18-2009, 09:55 PM	#7
Fazer Patron LugerForum Patron Join Date: May 2005 Location: Perth, West Oz Posts: 93 Thanks: 0 Thanked 7 Times in 5 Posts	Basicaly they wanted the hammer not to stike the firing pin if it slipped from your thumb while cocking it. I added a small block to the arch on the hammer, up the back. This gave me a half cook and a stopper for the hammer if it slipped. Luckely the sear raises enough to miss the block when the trigger is pulled, but is low enough to catch it when it's not. All in all, not a bad addition to be honest. But most of all it kept them happy.