Tool

Ron Wood · 08-12-2007, 04:59 PM

Look at the "shadow line" above and to the left of the crown. The mark was struck at an angle such that the left side of the impression is deeper than the right. In so doing, the fabricator revealed the flaw in a repro stamp. On a real stamp, the marking surface flows smoothly from the taper of the shank. On a repro stamp, there is a ridge around the characters of the stamp, so if you stamp it too deep or cockeyed the ridge shows up. I am sure this flaw will soon be fixed, but it is too late for this tool.

08-12-2007, 04:59 PM	#4
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,052 Thanks: 1,124 Thanked 5,289 Times in 1,729 Posts	Look at the "shadow line" above and to the left of the crown. The mark was struck at an angle such that the left side of the impression is deeper than the right. In so doing, the fabricator revealed the flaw in a repro stamp. On a real stamp, the marking surface flows smoothly from the taper of the shank. On a repro stamp, there is a ridge around the characters of the stamp, so if you stamp it too deep or cockeyed the ridge shows up. I am sure this flaw will soon be fixed, but it is too late for this tool. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode