barrel replacement

John Sabato · 12-20-2010, 08:32 AM

Accuracy is the the only test of whether or not your barrel needs to be replaced. I have seen Luger bores that looked like the inside of a sewer pipe that would print clover leaf bullet patterns in the X ring if you do your part. The design is inherently accurate, and a little pitting should not be a problem.

Shoot it... test it, and then decide if you need to change the barrel. I think your Luger may surprise you...

If you decide to replace the barrel/receiver... contact member LugerDoc...

Welcome to the Lugerforum.

12-20-2010, 08:32 AM	#6
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,157 Thanks: 3,003 Thanked 2,311 Times in 1,099 Posts	Accuracy is the the only test of whether or not your barrel needs to be replaced. I have seen Luger bores that looked like the inside of a sewer pipe that would print clover leaf bullet patterns in the X ring if you do your part. The design is inherently accurate, and a little pitting should not be a problem. Shoot it... test it, and then decide if you need to change the barrel. I think your Luger may surprise you... If you decide to replace the barrel/receiver... contact member LugerDoc... Welcome to the Lugerforum. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*