LugerForum Discussion Forums - View Single Post - Another one for the engineers!!! ......Luger mag shells! <IMG SRC="/luger/graphics/smile.gif" BORDER

G.T. · 04-05-2002, 07:01 PM

Hi Guys! so you think a low carbon steel was used with some kind of secondary tempering process? I have checked some of the coll rolled sheet steel in the correct thickness, and it is butter soft, It would form great, but would not last too long with even mild use! Are most alloy steels difficult to form? Thanks for the feedback guys! This is quite a learning experience for me! till....later....G.T.

04-05-2002, 07:01 PM	#6
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,545 Thanks: 1,345 Thanked 3,764 Times in 1,024 Posts	Thanks AGE & Viggo & ALL! So...Carbon steel, not alloy? Hi Guys! so you think a low carbon steel was used with some kind of secondary tempering process? I have checked some of the coll rolled sheet steel in the correct thickness, and it is butter soft, It would form great, but would not last too long with even mild use! Are most alloy steels difficult to form? Thanks for the feedback guys! This is quite a learning experience for me! till....later....G.T.